You can see the results of seven sequential runs here: I'm not sure why this is the case, except to suspect that the strain guage method of detecting contact with the bed is inaccurate. NO MORE DROPPING This is a simple method using a display coil spring reel with 2 bls of pull strength. On the wonky 2mm-out runs, measurement point 10 barely moves the Z-axis down before registering a hit. How you use this value is by only printing in layer heights that are divisible by 0.04, so 0.2mm, 0.16mm, 0.12mm and so on. 155 subscribers Subscribe 2.6K views 6 years ago Cetus3d Z Axis balancer. Will post more information as Cetus and the community address the issue further. I bought the Cetus 3D Printer MK3 recently and its working like absolute shit the print always slides with the extruder the software is comes with is absolute shit the print slides off the bed and sometimes the filament gets stuck in the extruder the bed adhesive sucks and the bed isn't heated and the calibration is terrible along with the print. Cetus3d z banding full Cetus3d z banding pro Cetus3d z banding series These full step layer height values mean you don’t have to kick into microstepping, which can give you uneven movement throughout the Z axis. The only other solution for the power loss z-axis drop is to keep the Cetus3D plugged into a UPS/battery backup. Udo has mentioned that he's working on a more thorough fix that would also help in the second condition, where the Cetus loses power.įor now, it seems a common fix is to place a piece of foam to catch the z-axis once it reaches a height that allows the foam to be slid underneath. This would only help with the first condition for z-axis drop, when a print completes.Īdditionally, Backer #1, Udo Nacken, has created a mechanical fix to the first scenario also which also gives the printer a nice resting position for the z-axis when not printing. He points out a file that should be deleted common to Up studio and the old version of the Cetus software. I asked Cetus support, and they told me z-banding was fixed. If power is lost at any time during a print, the z-axis drops.Ĭurrent Band-Aid fix by Cetus3D/Jason Wu can be found here.When a print completes, the z-axis rises to the top and then drops.Early backers that have received the Cetus3D have noted that the z-axis free-falls under two conditions. by Jackson OConnell Updated 3D printer Z banding, or Z wobble, is when regularly-spaced bulges form around the sides of a printed part.
0 Comments
Leave a Reply. |